ooooooooooo

Speedometer retaining ring

Colderweather86

Colderweather86

Well-known member
Lifetime Member
Joined
Apr 20, 2020
Messages
797
Points
63
Location
Palmer, AK, USA
Roxor #
7262
Roxor Ownership
Roxor Owner
Anyone else having problems with the speedometer retaining ring loosening up and the speedo falling out or wiggling in the hole? I have just over 200 miles on my Roxor, and it seems every time I drive it I am having to push the retaining ring back in place.

Has anyone found a "fix" for this?
 
Quite a few have had that problem, your dealer should be able to take care of it, should be under warranty.
 
I have heard some have taken it out and flattened it a bit with a hammer and put it back in, but you could also do more harm then good if you're not careful.
 
I had this happen when I was cutting into my dash for a switch panel. What a crappy design. I flattened it out with a hammer but am looking at some other mechanism
 
Yes a problem. 3000 miles , put a tab on dash to push it in. Next effort will be silicone or glue.
 
I am thinking of the silicon route, just a little bit on the outer bezel that could be easily separated with a razor blade if the speedo needs to be removed. Heck, I hooked up a scanguage 2, and I use it as it sits right over the steering wheel and is easier to view. Just got my new radiator and KMS ECU installed today so I’m back on trail
 
You must log in or register to reply here.
Back
Top