DIY doors

[OffRoad709]

Started working on my bathroom partition Roxor doors today. I measured the hood hinges and figured out that the bolt holes line up with the factory door hinge holes. Found a set of hood hinges on amazon for $35. Had a phenolic toilet partition door left on a job and it took me about 20 minutes to make the first one. The phenolic is 3/4” which is perfect. It leaves 1/4” for weatherstripping. Just need to decide on paddle latch or slam latch. Will probably paint them black but the phenolic is hard as a rock and very durable.

View attachment 2889 View attachment 2890 View attachment 2891

What's the rough measurements of the doors ? Looking to order material before I get my rig delivered

 

[OffRoad709]

Started working on my bathroom partition Roxor doors today. I measured the hood hinges and figured out that the bolt holes line up with the factory door hinge holes. Found a set of hood hinges on amazon for $35. Had a phenolic toilet partition door left on a job and it took me about 20 minutes to make the first one. The phenolic is 3/4” which is perfect. It leaves 1/4” for weatherstripping. Just need to decide on paddle latch or slam latch. Will probably paint them black but the phenolic is hard as a rock and very durable.

View attachment 2889 View attachment 2890 View attachment 2891

Hey, where did you get your fender flares?

 

[GiStore]

Pardon Our Interruption...

These are readily available OEM with complete fitting,Ready to bolt on
Hope this helps

 

[GiStore]

If anyone is looking for only OEM fittings for their DIY doors let me know i can arrange