2019 Roxor. Is the fitting plug marked with yellow the place to install the sending unit for a water temp gauge? Anyone know what thread and size it is? Attempting to install an Equus 8000 mechanical gauge. Thanks
ooooooooooo
Where to install water gauge on block?
- Thread starter Benjamin Breeg
- Start date
USMC
Active member
- Joined
- Jul 1, 2024
- Messages
- 403
- Points
- 43
- Location
- Naples Florida
- Roxor #
- 09848
- Roxor Ownership
- Roxor Owner
The actual OEM Temp Sensor is right behind the thermostat housing if you want to use that. It takes a 17mm wrench. I do not know the thread specs.
The bolt that you are referencing is the drain plug and that is a M12 x 1.5. The common Temp Sensor Thread is M12 x 1.5, BUT some use NPT threads.
The bolt that you are referencing is the drain plug and that is a M12 x 1.5. The common Temp Sensor Thread is M12 x 1.5, BUT some use NPT threads.
Last edited:
Thanks. As with all things Mahindra, I’m sure my most valuable tool will be a wine cork to seal the hole while I take the OEM plug to Ace to begin my adapter system to marry the temp gauge to the opening.
Similar threads
